How to measure

centimeter, equipment, inch-2261.jpg

Step One

Metal tape measure

pen, office, fountain pens-543858.jpg

Step Two

Pen or pencil

laptop, paper, to write-3076957.jpg

Step Three

Paper

Inside Mount

Let’s make sure you have what you need!  

  • metal tape measure
  • Pen and paper to record all measurements
  • Check if you have sufficient depth: Measure inside the window opening from the front to the back of the opening where the blind would mount. The depth must be at least 2 ¼” without a cassette valance and it must be at least 2 5/8″ with a cassette valance. To have a flush mount (fully recessed) the depth must be at least 3” without a cassette valance and it must be at least 3 ¼” with a cassette valance.. If your depth is not sufficient please see our outside mount instructions. 

Concerned about the light gaps that will occur on either side of the shade? Please choose an outside mount! 

 

How to Measure:

Let’s start with the Width:

  • Inside of the window opening/frame measure from left to right at the top of the opening.  If rounding is necessary, round down to the nearest 1/8”.  That is your ordering width.
  • Please note that when inside mounting with a cassette valance you are only able to mount at the top of the window frame.

Now, let’s do the Height:

  • Inside of the window opening/frame measure from the top of the opening to the bottom of the opening/sill on the left-hand side, the middle, and on the right-hand side. Write down all 3 measurements and circle the tallest. That is your ordering height.

Note: The factory will make the necessary deduction of approximately 1/8″ to your Width to allow for brackets.  The fabric will measure approximately 1 ½” less than the ordered width.  No deductions will be made to your Height.

 

 

 

 

Outside Mount

Let’s make sure you have what you need!  

  • metal tape measure
  • Pen and paper to record all measurements
  • Check if you have sufficient flat space. You must have at least 1 ½” when ordering without a cassette valance and you must have at least 2″ when ordering with a cassette valance.

How to Measure:

Let’s start with the Width:

  • Measure the width of the area you want to cover from outside edge to outside edge. Write down the measurement.  *That is your ordering width. If space permits we recommend adding 1-1 ½” on the left and right side for a total of 2-3″. This will help eliminate light seepage.
  • Please note that when outside mounting with a reverse roll it requires a top/ceiling mount.

Now, let’s do the Height:

  • Measure the height of the area you want to cover.  *That is your ordering height. Generally speaking, adding 3-4″ to the height of your opening (including molding or framework you wish to cover) will allow you room to mount above the window frame.

Note: The factory will make necessary deductions to your Width to allow for brackets. If you need to cover a specific width (e.g., for mounting a shade on a door) add 1 ½” to your ordered width. No deductions will be made to your Height.

Shopping Cart